Publicité
EN | VULCANO | User and Maintenance Manual
3 CLEANING
3.1 CLEANING OF THE VERTICAL MULTI-DECK DISPLAY
The equipment must be kept clean daily.
All cleaning operations must be carried out with the refrigerated table in stop position; the multi-
deck equipment as well as the built-in refrigeration unit must be completely powered off.
Attention! During cleaning operations, it is high recommended to use working gloves.
Avoid using products that contain chlorine or its diluted substances, as well as sodium hydroxide, abrasive
detergents, muriatic acid, vinegar, bleach or other products that may scratch or scrape the surface of the unit.
3.2
Never use high-pressure water jet to wash internal parts of the mulktideck equipment as electrical parts
could be damaged. Do not use heavy metal devices to remove ice. Only use warm water with non-aggres-
sive detergents to clean the refrigerated table; make sure to dry all wet parts using a soft cloth. It is advisable
to wash the bottom of the basin on a weekly basis, especially parts that are exposed to discharge of liquids or
other food waste. The external parts of the multideck equipment that surround the display area must also be
cleaned using cleansing agents: this will help keep the multideck equipment presentable free of encrustations.
ATTENTION
do not damage or bend the evaporator's fl aps or refrigerant fl uid pipes.
In order to avoid bacteria formation, the loading zone of the refrigerated table used for preser-
ving food products such are meat, salami or dairy products, must be cleaned at least once a week.
3.3 CONDENSER'S BUILT -IN UNIT CLEANING
Any operation of cleaning must be done disconnecting the electric
power supply.
The condenser of the Vertical Multi-deck Display with built-in unit must be
cleaned, in normal conditions of use of the Vertical Multi-deck Display, at least
once a month by using a vacuum cleaner and a real-bristle brush.
It is advisable to use gloves since the reduced thickness of the wings can cut.
Dirty condensing unit reduce the output ofthe engine causing an increase of
energy consumption.
Take care not to damage the refrigerating fl uid circuit.
The unit is on the top of the Vertical Multi-deck Display.
Attention! During cleaning operations, it is high recommended to use working gloves.
In order to ensure good operating performance, the condenser unit must be cleaned on a regu-
lar basis at least once at month.
30
Easy opening system
Unscrew the two screws positionig to the extremity part of the low
front panel of the multideck.
Open the front panel and pay attention to the electronic control
borad at your right side. For cleaning the condenser, please read the
note on the use manual at Condenser cleaning.
Publicité
Chapitres
