Black & Decker CS355 Mode D'emploi page 8

ENGLISH
•
Do not cut wood, plastic or synthetic
materials.
•
Do not cut cast-iron materials.
•
Never cut magnesium materials.
•
Do not cut electrically live material.
•
Use this tool in a well-ventilated area. Do not
operate the tool near flammable liquids,
gases or dust. Sparks or hot chips from
cutting or arcing motor brushes may ignite
combustible materials.
•
Regularly clear the ventilation slots when
working in dusty conditions. If it should
become necessary to clean the slots,
remember to unplug the tool first.
•
Always store cutting discs well-protected and
in a dry place, out of reach of children.
•
Warning! Use of this tool can generate dust
containing chemicals known to cause cancer,
birth defects or other reproductive harm. Use
appropriate respiratory protection.
Warning! Only use a chop saw wheel
with a maximum thickness of 3 mm
and a maximum diameter of 355mm.
Warning! The cutting wheel will continue to
rotate after the tool has been switched off.
•
Use only reinforced wheels rated 4300 rpm
or higher.
•
Always wear eye protection, use guards,
clamp work in vise, use proper respiratory
protection.
The following factors are of influence to noise
production:
•
the material to be cut
•
the type of the cutting disc
8
All manuals and user guides at all-guides.com
•
•
Residual risks
The following risks are inherent to the use of
these machines:
•
•
These risks are most evident:
•
•
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
•
•
•
•
Electrical safety
the voltage on the rating plate. Never attempt to
replace the charger unit with a regular mains
plug.
•
the feed force
Warning! Take appropriate measures for the
protection of hearing.
Injuries caused by touching the rotating parts
Injuries caused by disruption of the cutting
disc
Within the range of operation
Within the range of the rotating machine parts
Impairment of hearing.
Risk of accidents caused by the uncovered
parts of the rotating cutting disc.
Risk of injury when changing the disc.
Risk of squeezing fingers when opening the
guards.
Your tool is double insulated; therefore
no earth wire is required. Always check
that the mains voltage corresponds to
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.