Black & Decker CS355 Mode D'emploi page 12

ENGLISH
Consult your dealer for further information
on the appropriate accessories.
Performing a cut (fig. 1)
•
Place the material to be cut against the fence
(E) and secure using the vise (F).
•
Switch on the tool and pull down the handle
to cut the workpiece. Allow the motor to
reach full speed before cutting.
•
Allow the disc to cut freely. Do not force.
•
After completing the cut, switch off the tool
and return the arm to its upper rest position.
Transporting (fig. 1)
The tool is equipped with a lock chain (A) which
locks the tool in closed-down position for
carrying.
Warning: Ensure that the tool is switched off
and disconnected from the mains supply before
transporting.
•
Lower the guard (K) onto the cutting table
base (D) and secure the tool in this position
by securing the chain on the hook in the
handle.
•
Transport the tool using the carrying handles.
•
To release the tool, depress the operating
handle slightly and pull off the lock chain (A).
Maintenance
Your Black & Decker corded/cordless
appliance/tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper appliance/tool care and
regular cleaning.
Warning! Before performing any maintenance
on corded/cordless appliance/tool:
12
All manuals and user guides at all-guides.com
•
•
•
Mains Plug Replacement
If a new mains plug needs to be fitted:
•
•
•
•
Warning! If your product is class ll double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs.
Any replacement fuse must be of the same rating
as the original fuse supplied with the product.
Motor brush inspection and
replacement (fig. 9)
Warning! Turn off and unplug the tool. Be sure
the trigger switch is in the OFF position.
Brushes should be regularly inspected for wear.
To inspect brushes, remove brush cap (W).
Brushes (V) should slide freely in brush box. If
brushes are worn down to .3" (8mm) as shown in
Figure 9 they should be replaced.
To reinstall, push new brush back into brush box.
If replacing existing brush, maintain same
orientation as when removed. Replace the brush
cap (do not overtighten).
Switch off and remove the battery from the
appliance.
Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
Do not use abrasive cleaners.
Safely dispose of the old plug.
Connect the brown lead to the live terminal of
the new plug.
Connect the blue lead to the neutral terminal.
If the product is class l (earthed), connect the
green / yellow lead to the earth terminal.