R&G TG0018 Notice De Montage page 12

Page 12 of 12
serrer. Remarque: une petite quantité de composé de blocage de filetage sur les boulons est
recommandée pour maintenir le bloc de montage sécurisé.
• Faites glisser la protection de chaîne et de pignon (article 1) sur les fentes extérieures du bloc
de montage (article 2) et fixez-la à l'aide des deux boulons fraisés M6 (article 4) comme indiqué
sur le schéma d'assemblage 3, serrés au couple correct.
• En cas de montage avec des bobines de protection, reportez-vous à la légende pour
sélectionner le manchon de compression ou la rondelle de taille correcte et localisez le petit
bossage (le cas échéant) dans la fente verticale de la bobine de protection de l'extérieur et
installez la bobine comme indiqué dans l'exemple ci-dessous (dans ce cas, la rondelle anti-
rotation n'est pas necessaire).
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if
they were purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods
must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25%
of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges.
No returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does
not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
All manuals and user guides at all-guides.com
ISSUE 2 12/04/2021 (DM)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G
TG0018