Klarstein EasyCook Domino Mode D'emploi page 20

EN
20
All manuals and user guides at all-guides.com
INSTALLATION
Installing the ceramic hob
• The kitchen area should be dry and aired and equipped with efficient ventilation.
When installing the ceramic, easy access to all control elements should be ensured.
• This is a Y-type design built-in ceramic, which means that its back wall and one side
wall can be placed next to a high piece of furniture or a wall .Coating or veneer
used on fitted furniture must be applied with a heat-resistant adhesive (100 ).This
prevents surface deformation or detachment the coating.
• Hoods should be installed according to the manufacturer's instructions.
Important notes
• You must observe the ventilation
requirements shown in the drawing
opposite.
• There are ventilation holes around the
outside of the hob. YOU MUST ensure
that these holes are not blocked by the
work top, when you put the hob into
position (see drawing opposite).
• Do not use a silicon sealant to seal the
appliance against the aperture. This will
make it difficult to remove the hob from
the aperture in future, particularly if it
needs to be serviced.
Assembly of ceramic hob
• Make an opening with the dimensions given in the diagram for the hob to be
mounted on the worktop. Cut a hole in the worktop that corresponds with the
drawing shown above.
• Check seal for perfect fit and overall cover. Lower the ceramic hob into place and
align correctly.