Menu Guidance At Control Panel - Ten Haaft VISION CONTROL CENTER Mode D'emploi Abrégé

SHORT USER MANUAL VISION CONTROL CENTER

4. MENU GUIDANCE AT CONTROL PANEL

Menu-System Vision Control Center für Caro
Settings
Satellite settings
→ Manual search
→ Manual transponder
→ Receiver Control
→ DiSEqC allocation
24
Azimuth
Elevation
Skew
Save
→ Frequency
→ Polarisation
→ Symbol rate
→ FEC rate
→ Modulation rate
→ ONID
→ Active
→ Modus
→ Switch-On Delay
→ Switch-Off Delay
→ Mode
→ Mode
→ Sat 1 (manual)
→ DiSEqC-Position
→ Satellite
→ Sat 2 (manual)
→ ...
SHORT USER MANUAL VISION CONTROL CENTER
Left / right changes the azimuth (in increments of 1°)
Left / right changes the azimuth (in increments of 1°)
Left / right changes the elevation (in increments of 1°) Left / right changes the elevation (in increments of 1°)
Left / right changes the skew angle (in increments of 1°) Left / right changes the skew angle (in increments of 1°)
Saves the values and activates the mode Saves the values and activates the mode
Frequency in MHz (10500 - 12900)
Frequency in MHz (10500 - 12900)
High/Low
High/Low
Symbol rate (12000 - 45000)
Symbol rate (12000 - 45000)
Selection from a list of applicable FEC rates
Selection from a list of applicable FEC rates
"QPSK", "QPSK-S2" or "8PSK"
„QPSK", „QPSK-S2" or „8PSK"
Network ID
Network ID
"Yes" or "No". The display shows "Manual mode" when a manual transponder is active.
„Yes" or „No". The display shows „Manual mode" when a manual transponder is active.
"Off", "Automatic" or "OpenSleep" (LNB Off switches the system into sleep mode with the antenna remaining unfolded)
„Off", „Automatic" or „OpenSleep" (LNB Off switches the system into sleep mode with the antenna remaining
unfolded)
Delay until the next check of the LNB voltage for power-up (3–90 sec.)
Delay until the next check of the LNB voltage for power-up (3–90 sec.)
Delay until the next check of the LNB voltage for power-down (1–30 sec.)
Delay until the next check of the LNB voltage for power-down (1–30 sec.)
Four presets can be selected: "ten Haaft" (default), "manual", "NL Canal Digitaal" and "NL Joyne"
Four presets can be selected: „ten Haaft" (default), „manual", „NL Canal Digitaal" and „NL Joyne"
"Off" or 0 – 255 (position number of satellite)
„Off" or 0 – 255 (position number of satellite)
Name of satellite to be shown for this position
Name of satellite to be shown for this position
... as with "Sat 1"
... as with „Sat 1"
25