INSTALLATION
OUTSIDE MOUNT (OM)
•
With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 2 screws per bracket.
•
Use a level to ensure all brackets are aligned.
•
If more than two installation brackets come with your order, space additional bracket(s)
evenly between the two end brackets, no more than 30" apart, mark drill hole locations.
Headrail End Marks
2"
Space Evenly
Window Opening
•
Center the brackets on your marks, then mark each of the
screw holes.
— A minimum of 1
⁄
" flat vertical surface is required to
1
4
mount the brackets.
— The top of the installation brackets or extension brackets
should be at the desired shade height. The brackets
should be level and aligned.
— When using extension brackets, mark two screw holes
per bracket.
CAUTION: The rear of the brackets must be flush against a flat mounting
!
surface. Do not mount brackets on curved molding.
12
Cellular Shades Motorized Control Lift
Space Evenly
2"
Motor
Side
OUTSIDE MOUNT (OM)
Drywall
Anchor
Bracket
Screw
STEP 2: INSTALLING THE BRACKETS
NOTE: Use drywall anchors when mounting into drywall.
•
Drill the screw holes using a
⁄
" drill bit.
3
32
•
Attach the installation or extension brackets using the
screws provided.
IMPORTANT: The front edges of the installation brackets
must be level and aligned to each other.
•
If using spacer blocks for added clearance, the spacer blocks
and shims may be stacked.
— A maximum of 1
⁄
" of added clearance using spacer
1
2
blocks and shims is recommended.
•
Attach the spacer blocks and installation brackets to a flat
vertical mounting surface with #6 mounting screws long
enough for a secure installation.
— The top of the spacer blocks should be at the desired
shade height.
— If using extension brackets, attach an installation
bracket to the underside of each extension bracket
using the provided screws and speed nuts.
INSTALLATION
Longer Screw
(Not Provided)
Maximum
11/2"
Cellular Shades Motorized Control Lift
13