Levolor Cellular Shades Manuel D'installation, Fonctionnement, Entretien page 6

INSTALLATION
INSIDE MOUNT (IM)
STEP 2: INSTALLING THE BRACKETS
•
Drill the screw holes using a
⁄ " drill bit.
3
32
•
Attach the installation brackets
using the screws provided,
2 screws per bracket.
•
Ensure all brackets are square
with each other.
IMPORTANT: Use drywall anchors
when mounting into drywall.
STEP 3: INSTALLING THE
SHADE–MOUNTING THE HEADRAIL
•
Fit the front channel on top of the headrail onto the front
lip of installation brackets.
•
Push the headrail up and back until it snaps into place.
•
Check to ensure the headrail is securely in the brackets.
— Check that the bottom of the headrail is snapped into
the base of each bracket.
— Check that the front lip of each bracket is in the front
channel of the headrail.
— If any brackets are not installed correctly, release the
shade and reinstall. See "Removing the Shade
(If Necessary)" on page 17.
10
Cellular Shades Motorized Control Lift
Bracket
Bracket
Screw
Screw
Front Lip
Spring Tab
Headrail
The front of the bracket
fits under the groove.
Bracket
Headrail
Snap in
Place
Good Bad
OUTSIDE MOUNT (OM) –BEFORE YOU BEGIN
PAIR SHADE BEFORE INSTALLING
REMOTE CONTROL
•
Use the – and + buttons to select the channel
to pair to.
•
Press and hold the programming button on the
window covering for about 2 seconds until the
shade jogs once.
•
In the next 10 seconds, press and hold the  on
the remote until the shade jogs twice.
USING THE INMOTION APP
•
If you purchased a hub, download the LEVOLOR
InMotion app to get started.
™
•
Shade can be directly paired to app, but it is
recommended to pair to remote first.
OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET
LOCATIONS
NOTE: The rear of the brackets must
be flush against a flat mounting
Bracket
surface. Do NOT mount brackets
on curved molding.
•
Center the headrail over
the window opening at
the desired height.
•
Use a pencil to lightly mark
each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark
the headrail end points over the window opening.
•
Mark approximately 1 – 2" in from each end of headrail for the installation
bracket locations.
— Allow a minimum of ⁄ in between the bottom of the installation bracket and the
1
4
top of the window molding.
INSTALLATION
Standard Top-Down/Bottom-Up,
Remote Control Day/Night Remote Control
Programming
Button
Micro-USB
Charging Port
Indicator
Light
Cellular Shades Motorized Control Lift
11