Changing The Light Bulb - Whirlpool UKF8001AXX-750 Instructions D'utilisation

IMPORTANT: This cleaner is for stainless steel parts only!
Do not allow the Stainless Steel Cleaner and Polish to come into
contact with any plastic parts such as the trim pieces, dispenser
covers or door gaskets. If unintentional contact does occur, clean
plastic part with a sponge and mild detergent in warm water. Dry
thoroughly with a soft cloth.
3. Plug in refrigerator or reconnect power.
Clean the Condenser
There is no need for routine condenser cleaning in normal
home operating environments. If the environment is particularly
greasy or dusty, or there is significant pet traffic in the home,
the condenser should be cleaned every 2 to 3 months to ensure
maximum efficiency.
To clean the condenser:
1. Unplug refrigerator or disconnect power.
2. Remove the base grille.
3. Use a vacuum cleaner with a soft brush to clean the grille, the
open areas behind the grille and the front surface area of the
condenser.
4. Replace the base grille when finished.
5. Plug in refrigerator or reconnect power.
16

Changing the Light Bulb

IMPORTANT: The light bulbs in both the refrigerator and
freezer compartments use LED bulbs, incandescent bulbs or a
combination of the two. If the lights do not illuminate when the
refrigerator and/or freezer door is opened, call for assistance or
service. See "Warranty" for phone numbers.
1. Unplug the refrigerator or disconnect power.
2. Remove the light shield (on some models).
Top of the refrigerator compartment - Squeeze both sides of
■
the light shield while pulling downward to remove.
Beneath ice storage inclosure (on some models) - Press
■
along upper edge of light shield and roll light shield forward to
remove.
3. Replace the burned-out bulb(s) with a bulb of the same size,
shape and wattage.
To replace the burned-out LED bulb with a LED bulb,
■
order Part Number W10565137 (3.6 watts).
NOTE: Some LED replacement bulbs are not recommended
for wet/damp environments. The refrigerator and freezer
compartments are considered to be wet/damp environments.
If using a brand of LED bulb other than the recommended
LED bulb, before installation, read and follow all instructions
on the LED packaging.
When replacing an incandescent bulb, use only
■
incandescent bulbs for household appliances with a
maximum of 40 watts.
Reinstall bulb shield/shroud after replacing incandescent
■
bulb(s).
4. Plug in refrigerator or reconnect power.