EN
SAFE® Select Technology
When SAFE Select is activated, bank and pitch limitations keep you from over-controlling the aircraft.
Additionally, by releasing the controls in the event you lose orientation, SAFE Select will keep the
aircraft level.
To activate SAFE
Select, flip the Gear channel switch to position 0. Return the Gear switch to position 1 to
®
turn OFF SAFE Select and fly with just the assistance of AS3X
If you become disoriented or the aircraft is in a confusing attitude, flip the Gear switch to position 0 and
release the sticks. With the aileron, elevator and rudder sticks in the neutral position, SAFE Select will
automatically keep the airplane in a straight and level attitude.
Disabling and Enabling SAFE Select
By default, the SAFE Select function of your UMX aircraft is enabled and assigned to the Gear channel
switch (channel 5). If you do not wish to have access to SAFE Select while flying, you can choose to disable
SAFE Select functionality. AS3X will still be active when SAFE Select is disabled.
IMPORTANT: Before attempting to disable or enable SAFE Select, ensure the aileron, elevator, rudder,
throttle and gear channels are all on high rate with the travel set to 100%. Turn throttle hold OFF if it is
programmed in the transmitter.
CAUTION: Keep all body parts clear of the rotor, intake and exhaust tube and keep the aircraft
securely restrained in case of accidental throttle activation.
1. Power on the transmitter.
2. Power on the aircraft.
3. Hold both transmitter sticks to the inside bottom
corners and toggle the Gear switch 5 times
(1 toggle = full up and down). The control
surfaces of the aircraft will move, indicating SAFE
Select has been enabled or disabled.
Repeat the process again to re-enable or
disable SAFE Select.
DX4e, DX5e, DXe, and DXS Transmitters
The Gear switch is the FMODE switch on the these
transmitters, and the switch needs to be toggled
between position 0 and 2 when disabling/enabling SAFE Select.
6
technology.
®
Mode 1 and 2 transmitters
100%
X 5
100%