PRO-POINT Harris M Manuel D'utilisateur page 13

All manuals and user guides at all-guides.com
8345076 Harris Type Welder - Style M V 1.0
TROUBLE SHOOTING CHART
Problem Possible Causes Remedy
Increase pressure and constant
Tip is operated at too low heat valve
appropriate tip chart
Use next smaller
Welding Tip Popping
Tip too large
size tip
Too close to work Move tip further from work area
Flames not clearly defined,
Dirty tip Clean with tip cleaner or replace tip
smooth even
Regulator not holding
Defective seat Return unit for replacement
constant pressure
Too loose Tighten tip nut
Cutting Tip Popping
Nicked seat Replace tip
Leak around needle
Packing nut loose Snug packing nut valve
Difficult to light
Too much pressure Consult appropriate tip chart
Oxygen needle valve on torch
Open oxygen valve wide
handle partly closed
Flame change when cutting
Oxygen cylinder almost empty Replace cylinder with full one
13
For technical questions call: 1-800-665-8685