USING OVEN RACKS
The racks have a turned-up back edge that prevents the racks from pulling out of the oven cavity.
To remove racks
1. Pull the rack straight out until it stops.
2. Lift up the front of the rack and pull it out.
To replace racks.
1. Place the end of the rack on the support.
2. Tilt the front end up and push the rack in.
To remove or replace the racks properly, follow the steps illustrated below.
USING THE PARTITION
• To use twin mode operation, insert the partition.
• You cannot use the Self-Clean or Steam-Clean functions when the partition is installed in the
oven cavity.
• Handle the partition with both hands.
• Use oven gloves when inserting or removing the partition.
To Install the Partition into the Oven Cavity
1. Insert the partition into the 5th rack position of the cavity. See page
29.
2. Push the partition in until its back end rests against the back of the
cavity.
3. If the partition is installed correctly, the "-" icon appears on the
display.
Range displays "E-0C"
CAUTION
• Check the partition to see if it is installed correctly.
25_ Operating the oven
NE595R1ABSR_AC_DG68-00435A-03_EN.indd 25
2013-05-23
5:59:40