Publicité
Les langues disponibles
Les langues disponibles
Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
Hot surface indicator
• Comes on when the unit is turned on or hot to the touch.
• Stays on even after the unit is turned off.
• Glows until the unit is cooled to approximately 150 °F.
Cooking areas
• The cooking areas on your range are identified by permanent circles on the glass cooking
surface. For the most efficient cooking, fit the pan size to the element size.
• Pans should not extend more than ½˝ to 1˝ beyond the cooking area.
• When a control is turned on, you can see a glow through the glass cooking surface. The
element will cycle on and off to maintain the preset heat setting, even at high settings.
• For more information on selecting proper types of cookware, refer to the section "Using the
proper cookware" on page 23.
NE595R1ABSR_AC_DG68-00435A-03_EN.indd 18
6
1
5
3
2
1. Single element: Left rear
2. Single element: Right rear
3. Dual element: Left front (3,000W)
4
4. Dual element: Right front (3,000W)
5. Warming center: Center rear
6. Hot surface indicator
Surface cooking _18
2013-05-23
5:59:38
Publicité
