Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Telephone Operation
Out of Range
If the handset is too far from the base (out of range) you may
experience static or noise. Move closer to the base or handset will
automatically hang up if it is kept out of range for 30 seconds.
Battery Low
If the handset battery is low, the unit will emit the alert tone and
show BATTERY LOW in the display to remind you that the battery
needs charging. If the battery voltage is very low, the handset will
automatically shut down. Place handset in the charge cradle to
recharge battery.
Paging All Extension from the Cordless Handset
In the standby mode, press the INT button and then press zero (0)
button twice to activate page all extensions function.
Paging the Cordless Handset
This feature helps you locate a misplaced handset.
Press the PAGE button once on the base, then press number 0 button.
The cordless handset will beep continuously (if it is not out of range)
for 2 minutes or until you press any button on the handset.
NOTE: You may still page the cordless handset even if the ringer is
turned off.
Intercom Operation
Answering an Intercom Call
1.
Press the INTERCOM button or TALK button.
2.
When finished, press the INTERCOM button or TALK button again.
Receiving an Incoming Telephone Call During
an Intercom Call
During an intercom call, if you receive a telephone call, you will hear
an alert tone. To answer the incoming call, press the HOLD button to
place your intercom call on hold or press TALK or INT button to drop
the intercom call, then press TALK to answer the telephone call.
Using Intercom with a Telephone Call
During a telephone call, you can use the intercom function to page
another extension unit and set up a private (2-way) intercom
conversation with another user while the telephone call is placed on
hold. Or, you can create a 3-way conversation between the telephone
caller, the cordless handset and other extensions.
Two-Way Intercom Calls
1.
To make an intercom call, first press the HOLD button to place the
external call on hold. Then, press the INT button, and followed by
the extension ID number.
12
Publicité
