SEAL 54 EL-1 Manuel D'instructions page 23

8. If feeding cut sheet images:
•
Place a scrap piece of paper into the nip equal to width of the laminate and about 30 cm (12
in) long.
•
Hold scrap piece in place with one hand.
•
Lower top roll to full close (zero) position.
•
Feed images over scrap piece or last image tail.
When cutting sheet images, always leave enough scrap as to have some material in the nip
while being able to cut off the laminated image from the back of the machine. The film should never
come in contact with the bottom roll.
9. Pull off the film from the out-feed table (step 6) and fold down over bottom of lamination to prevent
it from sticking to the table again.
10. Use foot switch to start the process then switch to normal run with the forward button when ready.
5.3.3 Double Sided Process Webbing
Figure 17: Upper and lower section webbed.
The film in the upper section is webbed first
1. Pull the film forward until it almost reaches the in-feed table and lay it flat on the upper roller.
2. If the film has a release liner (B):
•
Install Wind-up Tube on machine.
•
If your machine has a splitter tube, web the film under the tube.
•
Peel back corner of release liner.
•
Pull the release liner off laminate and stick it to the tube with tape.
An empty card board tube from a used roll of film can be attached to the Wind-up tube to take
up the release liner. This allows the release liner to be easily removed from the Wind-up tube and
used for other processes if needed.
18
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920