Initial Setup Via Bluetooth - Marmitek Boomboom 160 Guide Utilisateur

INITIAL SETUP VIA BLUETOOTH

1. Switch on the
BoomBoom 160
by lightly pressing
down on the
control panel. The
top now rises.
2. Wait for
approximately 10
seconds. The
speaker will go
into pairing mode and will produce a "beep" tone. The red
and blue lights will light up alternately.
3. Turn on a device that supports Bluetooth, such as an iPod,
iPhone, Android or mp3 device and go to: Settings > General
> Bluetooth. Click ON the Bluetooth. BoomBoom 160 will
then appear on the device. Click ON the BoomBoom 160.
The device is now connected and paired with the speaker. If
the device prompts for a pair code, enter:"0000"
4. If pairing is not successful within 150 seconds, the
BoomBoom 160 will go into standby and the blue LED will
light up. To restart the pairing process, switch off the speaker
by pushing down the control panel and repeat step 1. If the
initial setup connection is successful, the next time the
speaker is turned on, the speaker will automatically pair to
the last device it was connected with.
! You can link to up to 8 devices however only 1 device can be
connected to the BoomBoom 160 at one time.
6 © MARMITEK