Publicité
Les langues disponibles
Les langues disponibles
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
9.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
9.2
REPLACE THE BLADE
18
20
19
WARNING
Use only approved replacement blades.
WARNING
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting nut (19) and spacers (20) with a
wrench or socket.
7. Remove the blade (18).
8. Install the new blade. Make sure that the posts engage the
holes in the blade.
9. Put in the mounting screw and spacers and tighten them.
English
9.3
•
Clean the machine before storage.
•
Make sure the motor is not hot when you put the machine
into storage.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
10
Problem
The handle is not
in position.
18
20
The machine does
19
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
11
STORE THE MACHINE
TROUBLESHOOTING
Possible cause
The bolts are not
engaged correctly.
The battery ca-
pacity is low.
The bail switch is
defective.
The lawn is rough. Examine the mow-
The blade height is
not set correctly.
Wet grass clip-
pings attach to the
deck.
The mulch plug is
missing.
The grass is too
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
EN
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
pack.
Replace the bail
switch.
ing area.
Move the wheels
to a higher posi-
tion.
Wait until the
grass dries before
mowing.
Install the mulch
plug.
Increase the blade
height.
Empty the grass
clippings from the
grass catcher.
Publicité
