Ega Master 57542 Manuel D'instructions page 26

Note:
1. If is appeared, that means this wrench has ever been applied more than 110% of
torque of the spec.
2. If is appeared, that means the wrench's memory is full and the next value record
can not be written in. Please refer the "Peak Hold Mode Recorded Value Review" section to
clear the momory records.
3. When 80% of the target torque is reached, the green LED will begin to flash and the alarm
tone will beep intermittently.
4. When the target torque is approached, the alarm will change to a steady tone and the
green LED will stop flashing and stay on. The red LED will also illuminate.
26
All manuals and user guides at all-guides.com
PEAK HOLD MODE OPERATION