Publicité
Les langues disponibles
Les langues disponibles
ATTENTION:
If an external force is applied to the torque wrench during power-on/reset or wake up period,
an initial torque offset will exist in the memory.
The wrench will auto sleep after about 5 minutes idle for power saving. Press
the wrench during the sleep mode.
CAUTIONS:
During communication period (Send appears), the sleep function is disabled.
- Press
together will reset the wrench.
- If the wrench does not function normally,
Press
together to reset the wrench.
If the battery serial voltage is in low voltage status, the wrench will display a battery symbol
and then turn off after a while.
- If you use the different head of the wrench, the reading on the display will be different for the
different length of the head. Please refer to the following explanation.
D : The set torque
D1: The actual torque applied to the nut.
L1: The extended length
L2: The normal length
L3: The length from the fitting pin to the calibration point.
All manuals and user guides at all-guides.com
ACTIVATION DURING SLEEP MODE
RESETTING THE WRENCH
LOW BATTERY VOLTAGE PROTECTION
WHEN CHANGING THE TYPE OF HEAD
Calibration Point
to wake up
21
Publicité
