LENCO L-83 Manuel D'instruction page 3

ASSEMBLY
Drive belt:
The belt and turntable platter have been installed properly at factory, but the belt
may be loose during transportation. If so, the following procedures will be taken for
belt installation by yourself.
A. Remove the rubber mat from the turntable platter and the E ring from the
turntable shaft, then release the turntable platter from the shaft
B. Put the drive belt on the inner rim of the turntable platter and pull it through the
hole
C. Hold the belt with your fingers and place the belt onto the motor pulley as
shown in the drawing.
D. Clip the E ring on the shaft and place the rubber mat onto the turntable platter.
Caution:
1. Make sure that the drive belt is not twisted or distorted.
2. Avoid oil. Oil splashes will make the belt slippery.
Auto Return Reset:
Always do the reset for Auto Return once you move this product. The mechanism
of Auto Return will rotate irregularly when moving and it will cause the malfunction
of Auto Return. The following steps will reset the mechanism to normal.
1. Place a record on the platter and play it.
2. Manually lever the tone arm and place it to the blank part of the end of the
record.
3. The mechanism of Auto Return function will be adjusted properly and the tone
arm will automatically return to the arm rest.
All manuals and user guides at all-guides.com
3