Publicité
Les langues disponibles
Les langues disponibles
Managing Device Properties
Viewing and changing appliance configuration information
The DSR switch can report most device properties directly through the DSR switch web
browser.
NOTE: Users can view all appliance information, but only administrators can change settings.
Table 4.5: Viewing Appliance Information
To do this:
Display the unit's name or type
Display a list of available target devices, their type
and status
Enter, change or display the unit's IP version,
network address, gateway address, subnet mask,
prefix length (if IPv6 mode), MAC address, LAN
speed, DHCP enable status, ICMP ping reply
status, SNMP enable status or primary, secondary
or tertiary DNS servers
Display the unit's current firmware revision for
application, boot and Video FPGA
Display a list of the attached IQ module and its
status
Display a list of active KVM sessions and their
duration
Display a list of active sessions
Display a list of devices attached to the DSR switch
View the unit's part number, serial number and EID
number
Enter or display the unit's Site, Department and
Location
Enable the Inactivity Timeout
All manuals and user guides at all-guides.com
Chapter 4: Web Interface Operations
Select this:
Appliance - Overview
Target Devices
Appliance - Appliance Settings - Network
Appliance- Appliance Settings - Versions
Appliance - Appliance Settings - Ports - IQ modules
Appliance - Appliance Settings - Sessions - Active
Appliance - Appliance Settings - Sessions - Active
Appliance - Connections
Appliance - Properties - Identity
Appliance - Properties - Location
Appliance - Appliance Settings - Sessions - KVM settings
Then click the Enable Inactivity Timeout box
57
Publicité
