Toro Recycler 55 Manuel De L'utilisateur page 22

Figure 31
Important:
Position the curved ends of the
blade to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt
to 82 N∙m (60 ft-lb).
Important:
A bolt torqued to 82 N∙m (60
ft-lb) is very tight. While holding the blade
with a block of wood, put your weight
behind the ratchet or wrench and tighten the
bolt securely. This bolt is very difficult to
overtighten.
All manuals and user guides at all-guides.com
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
g231390
21
1. Turn the adjustment knob counterclockwise to
loosen the cable adjustment
Figure 32
1. Handle (left side)
2. Adjustment knob
3. Self-propel-drive cable
2. Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the engine to
increase the traction; pull the cable away from
the engine to decrease the traction.
3. Turn the adjustment knob clockwise to tighten
the cable adjustment.
Note:
Tighten the knob firmly by hand.
(Figure 32).
g027231
4. Turn the knob clockwise to
tighten the adjustment.
5. Turn the knob
counterclockwise to
loosen the adjustment.
(Figure 32) by