Publicité
Les langues disponibles
Les langues disponibles
Pairing
1.
Press and hold the Volume Down button (2) of the deactivated parent unit.
2.
Switch on the parent unit by pressing and holding the On/Off button (1). The power indicator (3) starts flashing green. Release both buttons.
3.
Press and hold the Decrease Microphone Sensitivity button (8) of the switched-off baby unit.
4.
Switch on the baby unit by pressing and holding the On/Off button (7). The power indicator (9) starts flashing green. Release both buttons.
5.
Now press the Decrease Microphone Sensitivity button (8) of the baby unit once again. If the pairing process is successful, you will hear two beeps from the
parent unit. The power indicators of the parent unit (3) and baby unit (9) should now light up permanently green.
6.
The baby monitor is now ready for use.
7.
Repeat the pairing process if the parent unit and baby unit do not communicate with each other.
Baby unit / Transmitter
1.
During normal operation, the baby unit transmits in VOX mode. It only transmits the signal when the microphone of the baby unit detects any sounds. You can
use the buttons (8) on the baby unit to increase or decrease microphone sensitivity. The transmission indicator (12) flashes based on the sensitivity setting. At
highest sensitivity, the transmission indicator flashes 5 times, the baby unit transmits continuously.
2.
The transmission indicator (12) lights up yellow when the baby unit is transmitting sounds.
3.
To switch to low-radiation ECO mode, press the ECO mode button (10). ECO mode is indicated by the illuminated ECO mode indicator (10). Press the ECO mode
button again to switch back to normal mode.
! CAUTION: The out-of-range alarm is not active in ECO mode. You will therefore not receive a message on the parent unit if you are no longer within
range of the baby unit or if it is switched off.
Parent unit / Receiver
1.
If the parent unit receives a signal, the LEDs of the noise level indicator (4) light up in relation to the volume of the signal.
2.
You can increase or decrease the volume of the loudspeaker with the buttons (2). The set volume is indicated by the LEDs of the noise level display (4). The
loudspeaker is permanently muted when the volume is set to the lowest level, i.e. no LED is lit.
3.
If the parent unit is out of range of the baby unit for a period of more than 30 seconds, you will receive a visual and audible out-of-range alarm on the parent
unit. The alarm will only cease when you are back within range of the baby unit.
4.
The battery status of the batteries is indicated by the noise level display (4) of the activated parent unit by briefly pressing the On/Off button. If the battery level
of the parent unit becomes low, you will receive an optical and acoustic alarm. Then recharge the batteries. Please note that inserted batteries cannot be charged
in mains operation, but only externally.
Always disconnect the mains adapters from the wall power socket before cleaning the unit. Only use a slightly dampened cloth. Do not submerge the unit in water.
Do not use chemical detergents.
This product does not require any special maintenance. Repairs to the unit must be carried out by skilled personnel only.
Functional possibilities:
Cleaning and maintenance
Publicité
