Navman S100 Mode D'emploi page 8

Wiring Connection
• Keep electrical and transducer cables away
from alternator or other noise generating
electrical cables. Avoid connecting the
instrument to power circuits that share
loads with ignition, alternators, inverters and
radio transmitters. Electrical power supply
connections should always be as short as
possible.
Fuji
Plug &
Red
Socket
Black
Green
Blue
Wind
Transducer
6
Fuji
Plug &
Socket
Blue
Speed
Transducer
NMEA data to Wind
• Connect the red wire to the positive supply
via a 1 amp fuse or a 1 amp circuit breaker.
Connect the black wire to the electrical
ground. A 1 amp fuse will provide protection
for up to five 100 series instruments.
• Connect the 4 pin Fuji connector to the
speed and temperature transducer cable
connector. Extension cables are available if
the transducer cable is too short.
• If you are not using a repeater or you do
not intend to provide NMEA data to another
instrument then insulate the bare wire end
of the blue cable.
Red
Black
Red
Black
Blue
Speed
Transducer
1A Fuse
+12 VDC
Ground
NMEA output to repeater
Multiple Instruments
The NAVMAN S100 may be used
as an individual instrument or
connected with a number of other
100 series instruments to the 100
series repeater or to other
instruments accepting NMEA
0183 data.
1A Fuse
NMEA speed data to repeater
NMEA wind data to repeater
NAVMAN S100 User Manual
+12 VDC
Ground