Garland GAS 500 G Manuel D'instructions page 32

English
6.4.2. COLD START UP
1. Place the switch in the ON position (I).
2. Tighten the pump by priming the carburetor (7 to
10 times) several times to ensure that the fuel has
reached the carburetor.
3. Place the air lever in the closed position
4. Place the machine on the ground in a horizontal
and stable location.
5. Firmly hold the handle with your left hand pressing
the throtle.
6. Pull the starter rope until the engine makes an
explosion or start.
7. Place the air level in the normal
working position (open position).
8. If the machine has not started (you have only heard
an explosion) pull the starter rope again until it starts.
9. Allow the engine to warm up for a few minutes
before using the machine.
6.4.3. STARTING WITH A HOT ENGINE
If the machine is hot put the switch in the (ON)
position, making sure that the choke lever is in the
normal working position
the starter rope until the engine starts. If after a few
attempts the machine does not start, follow the steps
for starting with a cold engine.
6.4.4. STOPPING THE ENGINE
Stop accelerating and allow the engine to remain idle
for half a minute.
Stop the engine by turning the switch to the stop
position (OFF).
6.5. CHECKPOINTS AFTER STARTING THE MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
.
(open position) and pull
32/124
machine. If you detect any anomaly in the machine
immediately stop and check it carefully. In case of any
malfunction or problem take the machine to a service
technician to be repaired. Under no circumstances
must you continue to use the machine if the operation
does not seem appropriate.
Do not use the machine if it is damaged or
improperly adjusted.
7. USING THE MACHINE
Use this machine only for the designated
purposes. Using this blower for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.
Use this machine for blowing leaves or light materials
(paper, plastic...) of the ground and for grouping them
in a designated area. Do not use this machine for
other unintended purposes. For example: do not use
this machine to blow air at people or animals, to dry
objects or to stoke the fire. Do not use this machine to
move stones or sharp objects. The use of this machine
for other than the designed operations may result in
dangerous situations.
Do not only rely on and trust the security features of
this machine.
Do not use this machine if you are tired, ill, have taken
medicines, narcotic drugs or alcohol. The lack of rest
and fatigue can cause accidents or damage.
Limit the continued use of this machine to a 10
minute time limit and between 10 and 20 minutes of
rest between each session.
Never leave this machine unattended.