Garland GAS 500 G Manuel D'instructions page 30

English
6. START UP INSTRUCTIONS
6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you
will find inside the box:
• Blow tube A (nº 1).
• Blow tube B (nº 2).
• Cuerved blow tube (nº 3).
• Nozzle (nº 4).
• Machine
• Instruction manual.
4
3
Carefully remove all items from the box and make
sure that all listed items are present. Carefully inspect
the product to ensure that there are no damaged
elements.
If you find any damaged or missing parts, do not
use the machine until the defect has been repaired
or all the missing pieces replaced. Using the machine
without all of its parts or with defective parts can
cause severe personal injury.
2
1
30/124
6.2. ASSEMBLY
WARNING! To connect blowing pipes you must
insert tube in a way that will fit perfectly until it
reaches the bottom of the slot (1) and turn it tothe end
of the slot (2).
2
6.2.1. USAGE AS A BLOWER
1. Connect the two blowing tubes (no. 1 and 2).
2. Remember to insert the tube and rotate until you
reach the end of the groove.
2
3. Insert the tube in the air outlet of the engine as far
as you can.
1
1