Marantz SR4120 Mode D'emploi page 9

Remote control bus connections
This unit is equipped with a remote control function.
By connecting this unit's remote control jacks to a
Marantz CD player or tape deck equipped with remote
control (D-BUS) jacks, it allows system remote control
operation.
Connect REMOTE CONT. OUT jack of the receiver to
REMOTE CONT. IN of other Marantz equipment, i.e.
CD player or Cassette deck, by using an RCA pin
cable.
The sequence of connection between components
has no order.
Note:
If a component equipped with remote control (D-BUS)
jacks has an INT/EXT switch on the rear panel, set
the switch to EXT when using the system control
function.
(Connection example)
CD player rear panel
Receiver rear panel
REMOTE
REMOTE
CONT
CONTROL
IN
IN
OUT
OUT
PRE OUT jacks
The receiver is equipped with PRE OUT jacks. The
receiver has enough power for normal listening but
these jacks are prepared to connect other amplifiers
for higher power output. In such a case, connect these
jacks to the main input or AUX input jacks of the power
amplifier.
PRE-OUT
L
R
All manuals and user guides at all-guides.com
Tape deck rear panel
REMOTE
CONT
IN
OUT
MAIN IN or AUX IN
L
L
R R
POWER AMPLIFIER
BASIC OPERATION
Listening to the tuner
Press the POWER switch !0 to turn on the power.
1.
Press the AM/FM button y to select the desired
2.
band.
Adjust the TUNING UP and DOWN knob u to tune
3.
in the desired station. Adjust once for less than a
half second changes the frequency by one step.
Adjust longer sequentially scans frequencies in the
indicated direction. Releasing the button in this state
activates the auto tuning function, which
automatically scans the frequencies until it reaches
a station, at which point the TUNED and auto tuning
stops.
4.
Adjust the sound volume with the VOLUME control
i.
If necessary, adjust the tone controls (BASS/
TREBLE) ! 3 and ! 4 .
PRESETTING STATIONS
Up to FM/AM each 30 stations can be preset at
random, regardless of the reception band.
Tune in the station to be memorized using the auto or
manual tuning.
manual preset
Press the MEMO(memory) button r, then the
1.
"MEMORY" indicator lights up for about 5 seconds.
¡ When the MEMORY indicator goes off, press
again to memorize.
2.
Select the preset number with TUNING UP/DOWN
knob u.
Press the MEMO (memory) button r again.
3.
4.
Repeat steps 1 to 3 to memorize other stations.
¡When memorizing a new station, the prevision
memorized station the same preset number is
cleared.
auto preset
1.
The receiver is set in FM.
You keeps pushing MEMO (memory) button r at
2.
about 3 seconds.
3.
Then, tuner automatically begins scanning.
Scanning stops automatically after radio stations
have been stored in the Auto Preset memory.