Marantz SR4120 Mode D'emploi page 8

Rear panel connections
(see pages 5)
All connections to the rear panel should be made with
entire power off to the system. To avoid miss-
connection, it is advisable to connect one cable at a
time between the different components. This is the
safest way to avoid cross-connecting channels or mix-
up signal inputs with outputs.
A A A A A Antenna terminal
FM antenna terminal
For connecting an external FM antenna with a
coaxial cable, or for connecting a cable network.
AM antenna and ground terminal
For connecting the supplied AM loop antenna. Use
the terminals marked "AM" and "GND".
The supplied AM loop antenna will provide good
AM reception in most areas. Position the loop
antenna to the best reception.
B B B B B PHONO INPUT jacks
Connect the output jacks of a turntable to these
jacks.
C C C C C AUX(TV) INPUT jacks
Connect to the TV's (or other equipment) audio out
jack.
D D D D D TAPE input/output jacks
Connect the output (play) jack of the cassette deck
to the IN jack, and connect the input (REC.) jack
to the OUT jack.
E E E E E CD input jacks
Connect to the CD's audio out jack.
F F F F F REMOTE jacks
Connect to other Marantz components equipped
with REMOTE jacks. (see page 9)
Marantz components utilize the Philips RC-5
remote control system language.
G G G G G PRE OUT jacks
These jacks supply pre-amplifier output signals,
and are used for connection to external power
amplifiers.
(if necessary)
H H H H H SPEAKER terminals
Connect to the L or R channel speakers.
All manuals and user guides at all-guides.com
I I I I I AC outlets
Connect the AC power cable of a CD player,
cassette deck, etc., of your system. The power
supply from switched outlet is interlocked with the
POWER switch of the receiver.
The maximum total power consumption of the
connected components must not exceed the
following limit :
120 WATT MAX. TOTAL
J J J J J AC power cord
Plug into AC120V household outlet.
Note on loudspeaker impedance :
The power ratings specified for this Marantz
receiver are obtained using fixed value test load
impedance.
However, the actual impedance of a loudspeaker
system will vary with frequency, deviating from the
nominal rating.
This Marantz receiver will drive any modern loud-
speakers system with a rated impedance of 8 ohms
or higher.
A few newer loudspeakers feature impedance of
less than 8 ohms. The high current output capability
of this Marantz receiver can provide the additional
power necessary to drive such low impedance
speakers.
However, during extended passages of high
volume, the protection circuitry may temporarily
interrupt operation.
If this occurs, simply reduce the volume accordingly.
The protection circuitry is specially designed so
that it cannot affect the sound quality during normal
operation.