solamagic S2 Instructions De Montage Et D'utilisation page 107

Reprogramming
Selective
deletion: Previously programmed radio receivers can be deleted and
reprogrammed using the corresponding hand-held transmitter.
To do this, press and hold buttons 1 and 2 of the hand-held
transmitter simultaneously (longer than 3 seconds) until the red
control lamp on the hand-held transmitter illuminates. Deletion
is now enabled. Now release the buttons and directly thereafter
briefly press that key with which the wireless receiver was ope-
rated up until now.
The control lamp on the hand-held transmitter flickers briefly
when the deletion signal is sent. The heating tube switches to
low level and then off (LED A flashes continuously). The wireless
receivers enter the on-state and then switch off and on again.
These receivers can now be reprogrammed as described under
„Programming" above.
Complete
deletion:
Note: This action deletes all receivers that are within range of the
hand-held transmitter.
Programmed wireless receivers can also be deleted (reset)
upon loss of a hand-held transmitter or if it becomes defecti-
ve. The deletion process is only possible within 180 seconds of
connection to the mains of the receiver in question. (If necessa-
ry, disconnect the receiver from the mains and then reconnect.)
To delete, hold buttons 1 and 2 of the hand-held transmitter
pressed down (longer than 3 seconds). When doing so, the red
control lamp on the hand-held transmitter only illuminates once
deletion is enabled. Now release the keys and directly thereafter
briefly press both keys simultaneously for about 1 second.
The control lamp on the hand-held transmitter flickers briefly
when the deletion signal is sent. The heating tube switches to
low level and then off (LED A flashes continuously).
These receivers can now be reprogrammed as described under
„Programming" above.
107
10/2017