solamagic S2 Instructions De Montage Et D'utilisation page 106

Multiple
programming:
Safety
switch-off:
10/2017
It is possible to program radiant heaters on up to eight keys on
one or more hand-held transmitters (multi-control).
Connect the relevant heaters to the mains. As described un-
der „Initial programming", the key to be programmed is briefly
pressed, heating tube starts at low level (LED A flashes quickly).
Repeatedly pressing ensures that the heating tube goes to full
level (LED A flashes quickly).
Then the next key is activated by brief pressing, the heating
tube returns to the low level (LED A flashes quickly) and pro-
grams the following confirmation, the heating tube goes to full
level; LED A flashes quickly).
Then the next key is activated by brief pressing, the heating
tube returns to the low level (LED A flashes quickly) and pro-
grams the following confirmation, the heating tube goes to full
level; LED A flashes quickly). This process is repeated until all
the desired buttons on all the desired hand-held transmitters
are programmed.
The multiple programming is ended by long pressing of a key on
one hand-held transmitter. The heating tube goes off and then
on for 2 seconds (all three LEDs illuminate briefly).
The radiant heater always remains switched off after a power
outage.
106