solamagic S2 Instructions De Montage Et D'utilisation page 102

Step 1: Installing the T-bracket
• Install the radiant heater using 2 T brackets at a separation of 400 mm while
observing the safety distances and safety instructions (see Appendix 2).
• Secure the T-bracket (1) with the silicone plate (2) below it on the fastening
surface with 2 screws each according to the following figure. When wall-
mounted the heater swivels to the horizontal, lower longitudinal hole side.
If mounted on the ceiling, the swivelling range is limited to 30° relative to the
opposing longitudinal hole side to ensure optimum heating (deviating from the
illustration below).
15
Step 2: Installing adapter claws on the T-brackets
• Fit adapter claws (6) in the two T-brackets mounted on the fastening surface,
fit safety washer (12) between the T-bracket and adapter claw and screw in M6
socket cap screws (11) from outside into the T-bracket.
10/2017
12
2 1
6
102
11
A