Logitech KeyCase Mode D'emploi page 3

™
5. Reset the Palm handheld by tapping the Reset button. After resetting, if you have another keyboard driver installed
™
on your Palm handheld, or any other software that takes over the handheld serial port, you must disable it before connecting
® ™
the Logitech KeyCase
™
6. On the Palm handheld, tap the Logitech
have displayed.
™
7. Turn off the Palm handheld and connect it to the Logitech
Connecting/Removing the KeyCase
1. Remove the case strap as shown in picture A.
™
2. Unfold the KeyCase
picture B.
™
3. Attach the Palm V Series or Palm
handheld to the KeyCase
D. For a Palm ™ m100 Series connection, go to step 4.
C
™
The KeyCase and PDA stand should be
lying flat.
Line up the connector on the handheld
with the PDA stand connector.
F
. If not, the handheld may attempt to synchronize when you first use the KeyCase
®
icon to launch the driver software, then click "Done" after the Tips
and lay it flat as shown in
™
m500 series
™ as shown in pictures C and
D
Press the handheld onto the PDA stand connector.
The handheld should snap into place.
Raise the handheld and PDA stand into an upright
position.
Secure the PDA stand by placing the bottom end
of the stand against the ridge.
If you have followed the steps correctly,
the handheld will turn on.
Removing the Handheld from the PDA Stand
The KeyCase
Carefully press the handheld toward the base
of the PDA stand and at the same time lift the top end
of the handheld to release it from the PDA stand.
English
®
KeyCase
™
A
™
and handheld should be lying flat.
™
, as described in the next section.
B
E
Your handheld is now ready to use with
™
the KeyCase
"sleep," or is powered off in this position,
press any key to activate it. After it
wakes, the next key you press will type.
™
.
™
. If the KeyCase goes to
3