Publicité
Les langues disponibles
Les langues disponibles
16-CH
CHANNEL
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
CH 11
CH 12
CH 13
CH 14
CH 15
CH 16
5. DMX CONTROLLER
1. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120-ohm 1/4W resistor
between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last
unit.
2. Connect the unit together in a "daisy chain" by XLR plug cable from the output of the unit to the input of
the next unit. The cable cannot be branched or split to a "Y" cable. DMX 512 is a very high-speed signal.
Inadequate or damaged cables, soldered joints or corroded connectors can easily distort the signal and
shut down the system.
3. The DMX output and input connectors are pass-through to maintain the DMX circuit, when one of the
units' power is disconnected.
4. Each lighting unit needs to have a DMX address to receive the data by the controller. The address
number is between 0-511 (usually 0 & 1 are equal to 1).
5. The end of the DMX 512 system should be terminated to reduce signal errors.
6. 3 pin XLR connectors are more popular than 5 pins XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin4, Pin5 not used.
VALUE
0-255
0-255
0-255
0-255
0-255
0-255
0-255
0-255
AUTO RUN COLOR OPEN
0-255
0-255
0-255
0-255
0-255
0-255
0-255
0-255
COLOR AUTO RUN SPEED
FUNCTION
PAN (0-630)
PAN FINE
TILT (0-240)
TILT FINE
PAN & TILT SPEED
PAN & TILT AUTO RUN
AUTO RUN SPEED
DIMMER (0-100%)
STROBE
RED (0-100%)
GREEN (0-100%)
BLUE (0-100%)
WHITE (0-100%)
COLOR AUTO RUN
Publicité
