SX Lighting ROCKIN'HEAD Notice D'utilisation page 14

3.DESCRIPTION
FRONT
DMX LED : LED ON when DMX cable is plug
MASTER LED : LED ON when device is used as Master
SLAVE LED : LED ON when device is used as Slave
SOUND LED : LED ON when device works under Sound-Active mode
BUTTONS: MENU / ENTER / UP / DOWN
REAR
Power in / out : used to connect the device to power
Switch ON/OFF
DMX IN: use 3-pin XLR plug cable to link the DMX controller and the fixture, and input DMX signal
DMX OUT: use 3-pin XLR plug cable to link the next fixture and output the DMX signal
Fuse T 6.3A : to protect the unit from the damage of over-current
MAIN FUNCTIONS
Turn on the unit, press MENU button into menu mode, press UP and DOWN button until the required
function is shown on the monitor. Select the function by ENTER button. Use UP and DOWN button to
choose the submenu, press the ENTER button to store and automatically return to the last menu. Press
MENU button or let the unit idle one minute to exit menu mode.
In the event of disconnecting with mains power, press UP button for one minute to enter into menu mode.
Press MENU button or let the unit idle one minute to exit.