RIDGID RV2400A Mode D'emploi page 9

SP6636 1/10/07 9:52 AM
All manuals and user guides at all-guides.com
Drum/Caddy Assembly
If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all the
parts.
1. Remove left and right caddies from
drum.
2. Install cap nut on one side of shaft rod.
Tap gently with rubber mallet or hammer
until fully seated. Slide open end of shaft
through the wheel (smooth side of
wheel facing outward).
3. Place wheel/shaft assembly through
caddy left and on through the caddy
right, as shown.
4. Then place the remaining wheel onto
the caddy assembly (smooth side of
wheel facing outward), and install
second cap nut.
5. Invert drum to install caddy. Place the
caddy assembly onto the drum, as
shown. Be sure that wheels spin freely,
and do not contact the caddies.
6. Once the caddies are aligned on the
drum, gently tap each end of each
caddy until firmly
recommended to tap the center portion
of the front caddies, as shown.
7. Using a rubber mallet or hammer, gently
tap the wheel caps onto each wheel
until the wheel caps are firmly seated
onto each wheel. This is required on
both sides.
Page 9
NOTE: Smooth side of
the wheel to the outside.
Shaft
Rod
Caddy
Right
CADDY
ASSEMBLY
1/16" Clearance
seated. It is
9
Cap
Nut
Caddy Left
Wheel
Cap
Nut
Caddy
Wheel
TAP
TAP
Wheel Cap
Mallet