SP6480-5ES
8/24/06
Caster/Caster Foot Assembly
1. Turn the dust drum upside down on the
floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket of
the caster foot, as shown (4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.
Replacement Filter Assembly
1. Carefully slide the filter over the filter
cage, sliding it over the center ring
covering the 3 slots until the filter stops
against the lid.
2. Place filter nut and filter plate onto
threaded stud and tighten it down.
Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage, or
filter.
NOTE: If filter cage or float needs to be
replaced or removed, use a flat blade
screwdriver and insert the blade near one
of the tabs between the filter cage and the
center ring of the lid. Pry the tab out of the
slot. Tilt the cage and lift away from the lid.
To
replace,
follow
instructions below:
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac with
any parts damaged or missing.
10:28 AM
Page 5
the
assembly
5
Caster
Caster Stem
Caster Ball
Caster
Foot
Dust
Drum
Hole
Filter Nut
Lever
Pin
Filter Nut
Filter Plate
Filter
Threaded
Stud
Filter Cage
Slots (3)