Publicité
Les langues disponibles
Les langues disponibles
Only models without a display
If malfunctions or faults occur when a programme is running, the indicator light that
corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will
sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water supply is open, that the drain pipe is not bent
and that the siphon or filters are not clogged, set the selected program again.
If the fault persists, contact the Technical Assistance Centre.
This dishwasher is equipped with an overflow safety device that, in the event of a
problem, automatically discharges any excess water.
WARNING
To ensure the correct operation of the overflow safety
device, we recommend not moving or tilting the dishwasher
during operation. Should it be necessary to tilt or move the
dishwasher, please ensure that the washing cycle is
complete and that no water remains inside the appliance.
Other faults
FAULTS
1. No programme
works
2. Dishwasher
does not fill
with water
3. Dishwasher
does not
discharge water
4. Dishwasher
discharges
water
continuously
CAUSE
Plug not connected to wall socket
O/I button not pressed
Door is open
No electricity
See point 1
The water tap is closed
The water supply hose is bent
The filter of the water supply
hose is clogged
Filter is dirty
Drain pipe is bent
The drain pipe extension is not
correctly connected
The outlet connection on the
wall is pointing downwards not
upwards
Position of the drain pipe is too
low
Connect electric plug
Press button
Close door
Check
Check
Open the water tap
Eliminate the bends in the hose
Clean the filter at the end of the
hose
Clean filter
Eliminate the bends in the pipe
Follow the instructions for connecting
the drain pipe carefully
Call a qualified technician
Lift drain pipe to at least 40 cm
above floor level
115
SOLUTION
Publicité
