Candy CDIMQ 4D622PB/E Mode D'emploi page 104

l
Parameter adjustment is performed by
pressing the "SMART DOOR/EXPRESS"
and "TABS" buttons.
l
To adjust the SOFTENER see the specific
Chapter of the manual.
l
To adjust the BUZZER see the specific
paragraph.
l
To adjust the MEMO FUNCTION see the
specific paragraph.
"AUTOMATIC" programmes
(only on some models)
Models with Smart Loading Sensor
The "AUTO WASH" programme, thanks to
an algorithm that analyses the degree of
dirtiness of the dishes in real time,
automatically sets the ideal temperature
and washing time , optimising water and
electricity consumption
Models with dirt sensor
(Only on some models).
The dishwasher is equipped with a dirt
sensor, capable of analysing water murkiness
during all "AUTOMATIC"
phases (see programme legend). Thanks
to this device, the wash cycle parameters
are automatically adapted to the real
quantity of dirt on dishes. This is because
water murkiness is linked to the quantity of
dirt on dishes. Thus, excellent washing
results are guaranteed while optimising
water and energy consumption.
"IMPULSE" programmes
(only on some models)
The "IMPULSE" programmes use an
impulse washing technology, which reduces
consumption and noise, and improves
performance.
The "intermittent" working of the
washing pump
considered a malfunction; it is a
characteristic of impulse washing,
and therefore should be considered a
normal feature of the programme.
programme
is NOT to be
ADDISH
dishes after the programme has
started)
When the programme starts, you should
only open the door and add more dishes
when the ADDISH indicator light is switched
on. The appliance will stop automatically and
the time remaining to the end of the cycle will
flash on the display. Close the door, without
pressing any buttons.
Open the door slowly and carefully, to
avoid getting wet with splashes of
washing water.
Adding dishes
indicator light has switched off is
strongly discouraged as this could
affect the wash performance.
WARNING
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes)
automatically. Close the door, without
pressing any buttons. The cycle will start
from where it left off.
WARNING:
If you open the door during the drying
cycle, an intermittent audio signal
advises you that the drying cycle has
not yet finished.
104
(possibility of adding
after the ADDISH
the machine stops