Candy CDIMQ 4D622PB/E Mode D'emploi page 110

DISABLING REMOTE CONTROL
l
To exit remote control, press "PROGRAMME
SELECTION" again for 3 secs.
l
When no cycle is under way:
- The Wi-Fi indicator light will start
to flash slowly and the message
"REMOTE CONTROL OFF" will appear
on the display.
l
When a cycle is under way:
- The Wi-Fi indicator light will start to flash
slowly and the message "REMOTE
CONTROL OFF" will appear on the
display.
- The message "DOOR OPEN" will appear
on the display.
- The cycle will be completed without
control from the App.
Alternative way to exit remote control.
l
Press the "START/RESET" button for 3
secs
If there is a cycle under way, it will be
cancelled, and the machine will exit
REMOTE CONTROL mode.
The "Wi-Fi" indicator light will flash
slowly. It is now possible to set a new
wash cycle from the control panel.
l
Press the "ON/OFF" button for 3 secs
(or power off)
If there is a cycle under way, it will be
paused and the
REMOTE CONTROL mode.
On switching on again, the "Wi-Fi"
indicator light will flash slowly and any
cycle under way will continue from the
point of interruption.
Opening the door,
CONTROL will be disabled. To resume
control from the App, close the door.
machine will exit
any REMOTE
"Wi-Fi" indicator light
l
Indicates the connection status of the
product to the home Wi-Fi network. It can
be:
- SLOW FLASHING:
disabled.
- QUICK FLASHING FOR 3 SECONDS,
THEN OFF:
connect to the home Wi-Fi network or
has not yet been enrolled on the App.
- SLOWLY FLASHING 3 TIMES, THEN
OFF FOR 2 SECONDS: enrolment
procedure on the App in progress.
110
remote control
the machine cannot