Publicité
Les langues disponibles
Les langues disponibles
42 electrolux
1
Drainage filter
Clean the filter located at the base of the ap-
pliance regularly :
1
OPERATING PROBLEMS
Numerous checks were carried out on your
appliance before it left the factory. Howev-
er, should you notice a malfunction, please
Problems
The washing machine
doesn't start or doesn't
fill :
The appliance fills but
empties straight away :
The washing machine
doesn't rinse or doesn't
empty :
You have found water
around the washing ma-
chine :
Wash is unsatisfactory :
All manuals and user guides at all-guides.com
2
2
• the appliance isn't plugged in correctly, the electrical installation isn't
working, there is a power failure,
• the lid of your appliance and the drum shutters aren't closed firmly,
• the programme start command hasn't been properly selected,
• the water supply has been cut off, the water inlet tap is closed,
• the water inlet filters are dirty,
• a red tab appears on the water inlet hose
• the drainage U-piece is fixed too low (see installation section).
• the drain hose is blocked or bent,
• the drainage filter is obstructed,
• the out of balance detector has been activated : washing is unevenly
distributed in the drum,
• the "Drain" programme or "Night Silence Plus" or "Rinse hold" option
have been selected,
• the height of the drainage U-piece is unsuitable.
• too much detergent has caused foam to overflow,
• the detergent is unsuitable for machine washing,
• the drainage U-piece isn't attached correctly,
• the drainage filter hasn't been put back in place,
• the water inlet hose is leaking.
• the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
3
Water inlet filters
To clean, proceed as follows :
1
refer to the sections below before contact-
ing the after-sales service.
Causes
1)
.
4
Publicité
