Télécharger Imprimer la page

Craftsman 919.724570 Guide De L'utilisateur page 13

Publicité

Les langues disponibles

Les langues disponibles

All manuals and user guides at all-guides.com
Air Compressor Pump (not shown):
Compresses air into the air tank.
Working air is not available until the
compressor has raised the air tank
pressure above that required at the
air outlet.
Check Valve: When the air
compressor is operating, the check
valve is "open", allowing compressed
air to enter the air tank. When the air
compressor reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
Check Valve
Pressure Release Valve: The
pressure release valve located on the
side of the pressure switch, is
designed to automatically release
compressed air from the compressor
head and the outlet tube when the air
compressor reaches "cut-out"
pressure or is shut off. The pressure
release valve allows the motor to
restart freely. When the motor stops
running, air will be heard escaping
from this valve for a few seconds.
No air should be heard leaking when
the motor is running, or continuous
leaking after unit reaches "cut-out"
pressure.
How to Use Your Unit
How to Stop:
1.
Before Starting
Break-in Procedure
following break-in instructions are
not closely followed.
This procedure is required before the
air compressor is put into service and
when the check valve or a complete
compressor pump has been
replaced.
1.
NOTE: Pull coupler back until it clicks
to prevent air from escaping through
the quick connect.
On/Auto/
Off Lever
2.
3.
Pressure
Release
Valve
4.
13- ENG
Set the On/Auto/Off lever to
"OFF".
Serious damage
may result if the
Make sure the On/Auto/Off lever
is in the "OFF" position.
Quick
Connect
Plug the power cord into the
correct branch circuit receptacle.
(Refer to Voltage and Circuit
Protection paragraph in the
Installation section of this
manual.)
Open the drain valve fully
(counter-clockwise) to permit air
to escape and prevent air
pressure build up in the air tank
during the break-in period.
Move the On/Auto/Off lever to
"ON/AUTO" position. The
compressor will start.
Regulator
D24476

Publicité

loading