Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Contents of Carton
1 - Air Compressor
4 - Rubber Feet
Tools Required for Assembly
1 - 3/8" socket or nut driver
Assemble Rubber Feet
1.
Carefully place unit on side
opposite of controls.
2.
Using a 3/8 inch socket or nut
driver remove the screws
attaching the unit to the shipping
pallet.
NOTE: These screws will be used to
install the rubber feet.
HOW TO SET UP YOUR
UNIT
Location of the Air Compressor
Locate the air compressor in a clean,
dry and well ventilated area. The air
compressor should be located at
least 12" away from the wall or other
obstructions that will interfere with
the flow of air. The air compressor
pump and shroud are designed to
allow for proper cooling. The
ventilation openings on the
compressor are necessary to
maintain proper operating
temperature. Do not place rags or
other containers on or near these
openings.
GROUNDING INSTRUCTIONS
RISK OF
ELECTRICAL
SHOCK. In the event of a short
circuit, grounding reduces the risk
of shock by providing an escape
wire for the electric current. This
air compressor must be properly
grounded.
D24476
ASSEMBLY
3.
Attach the four rubber feet to the
unit's legs using the four screws
removed in step 2.
NOTE: Flat side of rubber feet goes
against unit legs.
INSTALLATION
The portable air compressor is
equipped with a cord having a
grounding wire with an appropriate
grounding plug (see following
illustrations). The plug must be used
with an outlet that has been installed
and grounded in accordance with all
local codes and ordinances.
1.
The cord set and plug with this
unit contains a grounding pin.
This plug MUST be used with a
grounded outlet.
IMPORTANT: The outlet being used
must be installed and grounded in
accordance with all local codes and
ordinances.
2.
Make sure the outlet being used
has the same configuration as
the grounded plug. DO NOT
USE AN ADAPTER. See
illustration.
Plug
Grounding Pin
10- ENG
Leg
Rubber
Foot
Screw
Grounded
Outlets
Publicité
