Functioning Of The Stimulator; Set Up Of The Stimulator; Check List Of The Parts; Battery Installation / Change - vygon Plexygon Manuel De L'utilisateur

2. FUNCTIONING OF THE STIMULATOR

2.1

Set up of the stimulator

2.1.1 Check list of the parts

Verify that inside the case, further to the stimulator, the following
accessories are included:
- 1 cable for connecting the stimulator to the needle .
- 1 alkaline battery 9V - 500 mAh (type 6LR61);

2.1.2 Battery installation / change

Open the panel in the back lower side of the stimulator by gently
pushing on the lever of the panel itself and pulling upwards .
Then connect an alkaline battery 9V-500mAh (type 6LR61) to the clip
inside the battery room, caring of the proper connection of the positive
and negative poles . Insert the battery in its room and close the panel
with a procedure opposite to the opening one .

2.1.3 Cables connection

Once the battery has been inserted and the back panel closed, set up
the double lead cable by inserting the three poles plug in the stimulator's
front socket . Thereafter connect the BLACK lead in to the needle
(negative electrode; black plug) and to the ECG electrode RED lead on
the patient electrode .
2.2

Stimulator's switch on / off

To switch the stimulator on, press the ON / OFF button on
the front panel .
By that the display will show the default set up: the current
associated to the supplied impulse (0,00 mA at the switching
on), the frequency (2 Hz) and the duration of the stimulus
itself (300 µS).
Before proceeding further, it's recommended to verify the proper
functioning of the stimulator according to the modalities described in
par. 3.2 (Check of the functioning).
To switch the stimulator off, keep the ON/OFF button pressed for 2 sec .
4