Husqvarna 572XPG Manuel D'utilisation page 34

Recommended cutting equipment
A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna 565, 572XP, 572XPG met
the safety requirements in ANSI B175.1-2012 and
Canadian Standards Association CSA Z62.1-15
(Chainsaws) and CSA Z62.3-11 (R2016) (Chainsaw
kickback), when equipped with the below listed saw
chain and guide bar combination(s).
Guide bar
Length, inch Pitch, inch
15 3/8
16
18
20
24
28
15 3/8
16
18
20
24
28
Filing equipment and filing angles
Using Husqvarna file gauge will give you the correct
filing angles. We recommend you to always use a
Husqvarna file gauge to restore the sharpness of the
saw chain. The part numbers are given in the table
below.
34
Accessories
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the
number of teeth (for example 10T). For solid guide bars
the nose radius is defined by the size of the nose radius.
For a given guide bar length, you may use a guide bar
with smaller nose radius than listed.
Gauge, inch Max. nose radi-
us
0.058 11T
34 mm
0.050 11T
34 mm
If you are not sure of how to identify what saw chain you
have on your chainsaw, please visit
www.husqvarna.com for more information.
Saw chain
Type Length, drive
links (no.)
Husqvarna H42 56
60
Husqvarna C85
68
Husqvarna H47
72
84
92
Husqvarna H46 56
60
Husqvarna H48
68
Husqvarna C83
72
84
93
140 - 003 - 05.11.2018