●
High-pressure. Keep clear of nozzle.
●
Injection hazard: Equipment can
cause serious injury if the spray
penetrates the skin. Do not point the
gun at anyone or any part of the
body. In case of penetration seek
medical aid immediately.
●
This system is capable of producing
1900 psi. To avoid rupture and injury,
do not operate this pump with
components rated less than 1900 psi
working pressure (including but not
limited to spray guns, hose and hose
connections).
●
Before servicing, cleaning or
removing any parts, shut off power
and relieve pressure.
●
If connection is made to a potable
water system, the system shall be
protected against back flow.
Water Supply
(Cold Water Only)
When connecting the water inlet to
the water supply mains, local
regulations of your water company
must be observed. In some areas
the unit must not be connected
directly to the public drinking water
supply. This is to ensure that there
is no feedback of chemicals into
the water supply. Direct connection
via a receiver tank or backflow
preventer, for example,
is permitted.
Use a water filter to avoid potential
damage from dirt in the water
supply
6 English
●
Garden hose must be at least
5/8 inch (16 mm) in diameter.
●
Flow rate of water supply must not
fall below 2 GPM/gallons per minute
(7.6 L/min).
●
Flow rate can be determined by
running the water for one minute into
an empty 5-gallon (18.9 liter)
container.
●
The water supply temperature must
not exceed 104°F/40°C.
●
Never use the pressure washer to
draw in water contaminated with
solvents, e.g. paint thinners,
gasoline, oil, etc.
●
Always prevent debris from being
drawn into the unit by using a clean
water source.
Ground Fault Circuit
Interrupter Protection
This pressure washer is provided with
a ground-fault circuit-interrupter
(GFCI) built into the plug of the power-
supply cord. This device provides
additional protection from the risk of
electric shock. Should replacement of
the plug or cord become necessary,
use only identical replacement parts
that include GFCI protection.