Danby DUFM505WDB Guide D'utilisation page 5

Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your freezer into its final location, it is important
to make sure you have the proper electrical connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your freezer be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the Temperature Control to the OFF
position as shown and then disconnect the freezer from the
electrical source.
Freezer Door
TOOLS NEEDED: ⁵⁄₈" hex-head socket wrench, ¹⁄₄" hex-head
socket wrench, ¹⁄₂" hex-head socket wrench, ³⁄₈" hex-head socket
wrench, #2 Phillips screwdriver, flat-blade screwdriver, ⁵⁄₁₆" open-
end wrench, flat 2" putty knife.
IMPORTANT:
All graphics referenced in the following instructions are
included later in this section after "Final Steps." The graphics
shown are for a right-hand swing door (hinges factory installed
on the right).
If you only want to remove and replace the door, see the
"Remove Door and Hinges" and "Replace Door and Hinges."
Before you begin, turn the control OFF, and remove food and
adjustable door or utility bins from door.
Install and Remove Handle
NOTE: If reversing the door swing, move the handle from one side
of the door to the other side.
To install handle:
1. Place the handle on the door as shown. See Handle graphic.
2. Using a flat-blade screwdriver, attach the handle to the door
with the four handle screws (provided).
3. Place the trim pieces on the upper and lower handle ends as
shown.
4. Apply firm pressure with your hand on the face of the trim.
Slide the top trim down and the bottom trim up toward the
handle.
To remove handle:
1. Remove the top and bottom trim.
2. Using a flat-blade screwdriver remove the four handle screws
and lift off the handle.
Remove Door and Hinges
⁵⁄₁₆
" Hex-Head Hinge Screw
1. Unplug freezer or disconnect power.
2. Open freezer door and remove base grille from the bottom
front of the freezer. See Base Grille graphic 1A.
3. Close the freezer door and keep it closed until you are ready
to lift it free from the cabinet.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
4. Remove the parts for the top hinge as shown in Top Hinge
graphic 1B.
5. Lift the freezer door free from the lower hinge and cabinet and
set aside.
6. Remove three hex head hinge screws and bottom hinge
assembly. See Bottom Hinge graphic 1C.
5