Danby DUFM505WDB Guide D'utilisation page 11

Changing the Light Bulb
NOTE: Not all appliance bulbs will fit your freezer. Be sure to
replace the bulb with one of the same size, shape, and wattage.
Style 1
1. Unplug freezer or disconnect power.
2. Replace the light bulb with an appliance bulb of the same
wattage.
3. Plug in freezer or reconnect power.
Style 2
1. Unplug freezer or disconnect power.
2. Remove the light shield. From the front of the light shield,
push backward and down.
3. Replace the light bulb with an appliance bulb of the same
wattage.
4. Replace the light shield.
5. Plug in freezer or reconnect power.
Try the solutions suggested here first to avoid the cost of an unnecessary service call...
Your freezer will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Is the power supply cord unplugged? Plug into a grounded
3 prong outlet.
If the power will be out for 24 hours or less, keep the door closed
to help food stay cold and frozen.
If the power will be out for more than 24 hours, do one of the
following:
Remove all frozen food and store it in a frozen food locker.
If a food locker is not available, consume or can perishable
food at once.
After the power is restored, unplug the freezer for 30 minutes, to
allow the refrigeration system to equalize. During this time keep
the door closed whenever possible.
REMEMBER: A full freezer stays cold longer than a partially filled
one. A freezer full of meat stays cold longer than a freezer full of
baked goods. If you see that food contains ice crystals, it may be
refrozen, although the quality and flavor may be affected. If the
condition of the food is poor, dispose of it.
When you are moving your freezer to a new home, follow these
steps to prepare it for the move.
1. Remove all frozen food.
2. Unplug the freezer.
3. Take out all removable parts, wrap them well, and tape them
together so they don't shift and rattle during the move.
4. Clean the freezer thoroughly.
5. Tape the freezer shut and tape the electrical cord to the
cabinet.
When you get to your new home, refer to the "Installation
Instructions" and "Freezer Use" sections for information on
installation and setting the controls.
TROUBLESHOOTING
Has a household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit breaker.
Is the Temperature Control turned to the OFF position?
See "Using the Control."
Is the freezer defrosting (on some models)? Recheck to see
whether the freezer is operating in 30 minutes. Your freezer will
regularly run an automatic defrost cycle.
Power Interruptions
Moving Care
11