Télécharger Imprimer la page

Trix Minitrix E 10.12 Serie Mode D'emploi page 7

Publicité

Safety Notes
• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
General Information
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
GB
Functions
• Trix locomotives can be operated on al 2-rail DC systems
with conventional DC power packs (12 volt DC).
• An electronic overload protection is build in to protect the
model.
• Triple headlights that change over with the direction of
travel.
• Close coupling between locomotive and tender.
• Locomotive comes with NEM 651
digital connector.
• Analog 14 volts DC, digital 22 volts AC.
• Trix motor vehicles must not be operated on digital
systems without an in-built engine decoder (Motor can
be damaged!).
• Based on the NEM 661 standard, the speed of the loco-
motive at 12 volts is set approximately at the maximum
speed for the prototype.
NEM
7

Publicité

loading

Ce manuel est également adapté pour:

11614