Tronic TKHU 2 A1 Mode D'emploi page 17

Handling and use
Fitting the car cradle
Unscrew the screw ring 4 anticlockwise from the
♦
car cradle.
Place the screw ring 4 over the ball joint 9 and
♦
press the ball joint 9 into the ball joint socket 5
(see fig. C).
Screw the screw ring 4 clockwise onto the ball
♦
joint socket 5 until tight
Fitting the vent clip
Pull the lever 1 towards the car cradle and hold it
♦
in place.
Guide the hook 2 between two ventilation slots
♦
and hook it onto a ventilation slot.
Release the lever 1 slowly and, at the same time,
♦
place the two cut-outs 3 onto a ventilation slot.
Align the car cradle so that the two arms of the vent
♦
clip rest on the fitting. You can use the 360° rotating
ball joint 9 to adjust the car cradle horizontally
and vertically to suit your requirements. Loosen the
screw ring 4 a little to make it easier to adjust the
ball joint 9.
TKHU 2 A1
GB │ IE │ NI │
13 ■