Operation Of The Leds - ADEUNIS LoRaWAN TEMP Guide Utilisateur

LoRaWAN TEMP - Guide utilisateur / User guide version V1.2.0

2.3. Operation of the LEDs

Mode
Transmission of frame (test mode only)
Product in Park mode
Magnet detection process (1 to 6 seconds)
Product start (after detection of the magnet) Off
Joining process (Lora product)
EN
Switching to the Command mode
Battery level low
Product faulty (return to factory)
Product in production mode
LED red state
Off
Off
During the JOIN phase: flashing: 50ms on / 1
s off
If the JOIN phase is complete (JOIN accept):
flashing: 50ms on / 50ms Off (6x)
Continuously lit
Flashing (1s ON by 30S)
Fixed
50ms on / 30 s off
LED green state
Flash at the beginning of the transmission
cycle
Off
ON from detection of the magnet up to a
maximum of 1 second
Rapid flashing 6 cycles, 100 ms on / 100
ms Off
During the JOIN phase: flashing: 50ms on /
1 s off (just after the red LED)
If JOIN phase is complete (JOIN accept):
flashing: 50ms on / 50ms off (just after the
red LED)
Continuously lit
50ms on / 30 s off (just after the red LED)
56 of 79